Assembly - Ironman Fitness LXT 850 Owner's Manual

1
Install the Rubber Pad (24) onto the
Front Frame (2).
Stand up the base of the machine
by separating the frames. Pull the
Front, Left and Right Rear Frames
(2, 10, 1) as far apart from each
others as possible. Then push
down on the middle of the two
Folding Arms (18) until they are
fully locked down.
Attach the Front Foot Stabilizers
(35) to the Front Frame (2) each
with one M6x20 Phillips Bolt (68)
and Ø6.5xØ16xt1.0 Washer (86).
Attach the Rear Foot Stabilizers (36)
to the Left and Right Rear Frames
(10, 1) each with one M6x20
Phillips Bolt (68) and Ø6.5xØ16xt1.0 Washer (86).
Attach both Left and Right Protective Covers (40L, 40R) onto the Front, Left and
Right Rear Frames (2, 10, 1) with the velcro straps on the side of the Left and Right
Protective Covers (40L, 40R) to secure the covers to the Front, Left and Right Rear
Frames (2, 10, 1). Pull down on the Left and Right Protective Covers (40L, 40R)
until the bottom of the covers are slightly lower than the Folding Arms (18). When
the covers are assembled correctly, the Folding Arms (18) should be fully covered by
the Left and Right Protective Covers (40L, 40R).
2
Attach the Handlebars (15) onto the
Left and Right Rear Frames (10, 1)
with two M10x45 Allen Head Bolts
(62), M6x15 Allen Head Bolts (63),
Ø6.5xØ16xt1.0 Curve Washers
(87), M10 Lock Nuts (90), and four
Ø11xØ20xt2 Washers (black) (83).

ASSEMBLY

10