Stand-By Operation - Sennheiser EM 3532-U Instructions For Use Manual

19

Stand-by operation

The EM 3532 receiver can be set to stand-by operation. During stand-by operation, information
from the RF section is no longer processed and the AF section is muted (MUTE). All other menus
– except for "REMOTE" and "STANDBY" – are locked. If you try to select any other menu, "Loc"
appears on the display.
Press the /
"OFF" – is indicated on the display.
Then press the
You can now select your desired setting:
Press the
Press the
Your setting has to be stored before it becomes effective. To store a setting, press the
button until "Sto" briefly appears on the display, indicating that your setting has been
stored. The display then switches back to the standard display.
If the receiver is set to stand-by operation, the "STANDBY" display on the display panel is lit
up.
You can discontinue the programming of this menu at any time by briefly (!) pressing the
button. The previous setting is then kept. If you do not press any of the three
SET
programming buttons for more than 30 seconds, the setting mode is automatically left and
the previous setting is also kept.
buttons to select the "STANDBY" menu. The current setting – i.e. "On" or
button. The "STANDBY" display on the display panel begins to flash.
SET
button to switch on the stand-by operation, "On" appears on the display:
button to switch off the stand-by operation, "OFF" appears on the display:
SET
61