Clearaudio Nano Phono V2 User Manual page 3

Congratulations on the purchase of your new Nano Phono V2/ Nano Phono
"H" V2 MC/MM phonostage.
The Nano Phono V2/ Nano Phono "H" V2 features a power switch: we
recommend that you keep the unit switched on in order to maintain a constant
temperature for the electronic parts inside (this uses very little power). The new
Nano Phono V2/ Nano Phono "H" V2 also has a built-in volume control unit.
IMPORTANT!
First, select either the MC (moving coil) or MM (moving magnet) mode according
to your cartridge type, by inserting the removable jumpers into the relevant
positions on the bottom of the unit (one each for left and right channels).
The subsonic-filter function can also be adjusted by inserting jumpers into the
relevant points on the bottom of the unit:
. I
subsonic filter is OFF f the jumper is not inserted, then the subsonic filter is ON.
The next step is to connect the ground wire of the turntable/tonearm with the
Nano Phono V2/ Nano Phono "H" V2. Make sure that the gain control is set
to its lowest volume before connecting the Nano Phono V2 / Nano Phono
"H" V2 to your MC/MM cartridge and preamplifier.
Finally, the very last thing to do is to connect the power supply to the mains and
press the power switch to the "ON" position.
- Attention -
Never cover or put anything on top of the Nano Phono V2/ Nano Phono "H"
V2 as this could lead to overheating of electronic parts.
1. If you are using the Nano Phono V2/ Nano Phono "H" V2 with a two-pin
mains plug, you may notice that inserting the plug into the mains socket one way
round gives a slightly better sound than the other way. Experiment to identify
which is the optimum position.
2. Phonostages provide a very high level of amplification, to address the fact that
the electrical signal generated by a phono cartridge is extremely low. As a result,
phonostages are extremely sensitive, which leads to the potential problem that
English
- Set up -
if the jumper is inserted, then the
- Notice -
high-frequency interference may also be amplified to a point at which it becomes
noticeable. Unfortunately it is not possible to completely protect the sensitive
phonostage circuitry from this interference without degrading its high fidelity
performance.
Therefore care must be taken to position the phonostage away from sources of
high frequency interference such as mobile phones, modems and powerline
communication systems (PLC) in which data is sent over the mains power
network.
Clearaudio electronic GmbH
Spardorfer Str. 150
91054 Erlangen
Tel/Phone: +49 9131/40 300 100
Fax: +49 9131/51683
www.clearaudio.de;
www.analogshop.de
(Technical changes may be made without prior notification; products will be available as long as stock lasts)
Germany
info@clearaudio.de