Windowsme/98/95 Settings; Checking After Installation - Buffalo WLI-PCM-L11GP User Manual

3

WindowsMe/98/95 Settings

This chapter describes the setting procedures for the WLI-PCM-
L11GP when using WindowsMe/98/95.

Checking after installation

After installing the driver, follow the steps below to check that the WLI-
PCM-L11GP is operating correctly.
1
Click the Start button and select Settings - Control Panel.
2
Double-click the System icon.
3
Click the Device Manager tab. Select "MELCO WLI-PCM-L11GP
Wireless LAN Adapter" and click the Properties button.
• If "MELCO WLI-PCM-L11GP Wireless LAN Adapter" is not listed, click the
+ mark on the left of "Network adapters".
• "PCMCIA card service" may be included in "Other devices", however, this does
not imply any problem.
4
Check that the message "This device is working properly" is dis-
played for Device status.
If the above message is not displayed, the WLI-PCM-L11GP is
not operating correctly. Uninstall and re-install the driver, referring to
"The installation screen does not appear." on page 33 in Chapter 6.
5
Click the Start button and select Settings - Control Panel.
6
Double-click the PC Card (PCMCIA) icon.
Continued on next page
WLI-PCM-L11GP User's Manual 19