Buffalo WLI-PCM-L11GP User Manual page 16

When an error mark ("!" or "X") is displayed
Follow the steps below to change your PC card driver configuration.
1 Double-click PCMCIA controller with an error mark. PC Card (PCMCIA)
Wizard starts.
2 The message "Welcome to the PC Card (PCMCIA) wizard......" Appears.
Select "No", then click Next.
3 The message "Windows did not find any existing real-mode PC card driv-
ers......" Appears. Select No, then click Next.
4 The message "You have finished the PC card wizard." Appears. Click Fin-
ish.
With Windows 98, the configuration is now comleted. Open Device Man-
ager tab and check that no marks indicating a problem ("!" or "X") are dis-
played for PCMCIA controller.
5 With Windows 95, the message "To continue the configuration of this PC
card, you are required to shut down Windows and turn off the com-
puter......" Click Yes.
6 After Windows restarts, Open Device Manager tab and check that no
marks indicating a problem ("!" or "X") are displayed for PCMCIA controller.
* If you still have a problem with the installation, refer to the
manual of your computer or contact the manufacturer of
your computer.
Go to "Installing the WLI-PCM-L11GP" on page 16 .
14 WLI-PCM-L11 User's Manual