OM-CC-E
The colon [:] between the numbers on the time
display will blink and the generator will begin to
produce steam. The time will not count down
unless the READY light is lit.
NOTE: You cannot change modes if the timer is
running.
8. To Test Combo Mode Operation, turn on the
power and clear any time from the timer display.
Press the COMBO touch pad. Set the COOK
o
temperature to 300
F (150
will come on. It will remain on while (1) the
steam generator fills with water and heats it to
its standby temperature and (2) the air heater
raises the air temperature to 300
actions should be completed in about five
minutes, starting with a cold unit. When the set
temperature is attained, the WAIT light will go
off, and the READY light will come on.
NOTE: The timer does not control the oven in
either the Combo or Oven Modes.
o
C). The WAIT light
o
F. Both
9. To Test Oven Mode Operation, turn on the
power and clear the timer display. Press the
OVEN touch pad. Set the cook temperature to
o
o
350
F (175
C). The WAIT light will come on.
Within six minutes from a cold start, the WAIT
light should go out and the READY light should
come on. When that happens, turn the COOK
temperature setting down to 320
HOT light will come on.The heat-up times
provided above may vary slightly as a result of
voltage or water pressure differences.
10. To shut down the unit, first clear the timer. Next,
press the mode pad for the mode in which the
unit is operating. Finally, switch off the power.
11. If your Convection Combo™ behaves as
described, the unit is functioning correctly, and is
ready for use.
12
o
o
F (160
C). The
Need help?
Do you have a question about the CONVECTION COMBO CC-E series and is the answer not in the manual?