Groen CONVECTION COMBO CC-E series Operator's Manual page 11

ANY POTENTIAL USER OF THE EQUIPMENT SHOULD BE TRAINED IN SAFE AND CORRECT OPERATING
PROCEDURES.
After the Convection Combo™ has been installed,
test it to ensure that it is operating correctly.
1. Remove all literature and packing materials from
the interior and exterior of the unit.
2. Check that the cold water supply line is open and
that none of the fittings are leaking.
3. Turn on electrical service to the unit.
4. High Altitude Operation. At altitudes above
5,000 feet (1524m), the unit will not operate in
the Steamer or Combo Modes unless the altitude
is set. You can program the altitude as follows:
a. If the unit is on, turn it off by pressing the ON
touch pad.
b. Press and hold the STEAM touch pad while
turning the unit on by pressing the ON touch
pad. The Timer Display will show the letters
AL and a number representing the altitude in
thousands of feet. If the altitude has not
been set for your unit, the display will be 0.
c. Enter an altitude value between 0 and 15,
using the numbered touch pads. For
example, if the unit will be operating at 7,000
feet, enter 7.
d. Press the START touch pad.
Altitude Metric Conversion
Altitude
Feet Meters
5000
6000
7000
8000
9000
10000
11000
12000
13000
14000
15000
Initial Start-Up
Setting
1524 5
1830 6
2133 7
2438 8
2745 9
3048 10
3353 11
3658 12
3962 13
4267 14
4572 15
WARNING
5. For CC20-E only: Check Fan
Rotation — IMPORTANT! As
seen from inside the oven cavity,
the fan should be turning in a
counterclockwise direction. If the
fan is running backwards
(clockwise), have a qualified
electrician turn off the main power and switch
any two incoming power leads on the distribution
block. An incorrectly turning fan will eventually
shut the oven down.
6. Select Farenheit or
Celsius
Temperatures. The
Convection Combo™
is delivered with the
Farenheit scale as
default. To change
the current
temperature scale,
holding the 5 key in,
press ON. The Timer
Display will either
show dEG°F or
dEG°C. Press the 5
key again to change
from one to the other. Press START to accept
the change.
7. To Test Steamer Mode Operation, turn on the
unit. (For details of operating procedure, see the
Operation section of this manual.) Clear time
from the time display. Press the STEAM touch
pad. (If the HOT light is on, see the Fast Cool
instructions in the Operation section.)
The WAIT light will stay on while the steam
generator fills with and heats the water. The
WAIT light should turn off within three minutes,
and the READY light should come on. This
indicates that the water is at its standby
temperature. The timer only controls operations
in the Steamer Mode. Enter a time and press
START. ("Time" is set in minutes and hours
only. Seconds are not displayed).
Examples: 2 minutes = 00:02
11
OM-CC-E
(Just press 2).
1 hour and 30 minutes = 01:30
(Press 1, 3, and 0, or press 9,0
the timer will change to 1:30)