16-Port 10/100Mbps + 2-Port Gigabit Unmanaged PoE Switch
Keep a reasonable cabling system and avoid induced lightning.
■
Use the signal SPD (Surge Protective Device) when wiring outdoor.
■
Note:
For detailed lightning protection measures, please refer to the Lightning Protection Guide
from the training center of our website:
https://www.tp-link.com/en/configuration-guides/lightning_protection_guide/?configurationId=2962
Installation Site
When installing the device on a rack or a flat workbench, please note the following items:
The rack or workbench is flat and stable, and sturdy enough to support the weight of 5.5kg at least.
■
The rack or workbench has a good ventilation system. The equipment room is well ventilated.
■
The rack is well grounded. Keep the power socket less than 1.5 meters away from the device.
■
2.3
Installation Tools
Phillips screwdriver
■
ESD-preventive wrist wrap
■
Cables
■
Note:
These tools are not provided with our product. If needed, please self purchase them.
2.4
Product Installation
Desktop Installation
■
To install the device on the desktop, please follow the steps:
1. Set the device on a flat surface strong enough to support the entire weight of the device with all
fittings.
2. Remove the adhesive backing papers from the rubber feet.
3. Turnover the device and attach the supplied rubber feet to the recessed areas on the bottom at
each corner of the device.
Figure 2-1
Desktop Installation
6
Installation
Feet
Bottom of the Device
Notch