Related Manuals for Silicon Laboratories MGM13P02
Summary of Contents for Silicon Laboratories MGM13P02
- Page 1 INSTALLATION GUIDE Alberga Business Park, Bertel Jungin aukio 3 FI-02600 Espoo, Finland Phone: +358 9 435 5060 www.silabs.com...
- Page 2 2.14 dBi Table 1: Qualified antennas for MGM12Px The MGM13P02 modules are in conformity with the essential requirements and other relevant requirements of the Radio Equipment Directive(RED). Please note that every application using the MGM12P will need to perform the radio EMC tests on the end product according toEN 301 489-17.
- Page 3 38 mm is maintained between the radiator (antenna) and all persons at all times. • With MGM13P02 the antenna(s) must be installed such that a minimum separation distance of 7.7 mm is maintained between the radiator (antenna) and all persons at all times.
- Page 4 “Contains Transmitter Module FCC ID: QOQMGM13P” “Contains FCC ID: QOQMGM13P The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module or change RF related parameters in the user manual of the end product.
- Page 5 additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or co-location with another transmitter), then the ISEDC authorization is no longer considered valid and the IC ID cannot be used on the final product.
- Page 6 • L'antenne (s) doit être installée de sorte qu'une distance de séparation minimale indiquée ci-dessus soit maintenue entre le radiateur (antenne) et toutes les personnes avoisinante, ce à tout moment. • Le module émetteur ne doit pas être localisé ou fonctionner avec une autre antenne ou un autre transmetteur que celle indiquée plus haut.
Need help?
Do you have a question about the MGM13P02 and is the answer not in the manual?
Questions and answers