Table of Contents
Advertisement
- This is to prevent accidental out of range temperature setting.
7. Heating Element
Parameter HU and HD, set by factory and is not supposed to be modified by user.
HU - Default setting is 18 ( I believe it's Heat Up power setting, controlling the start up power
to the heater to bring it up to the desired temperature setting (incubating temperature ad-
justment). Setting Range 1~90.
HD - Default setting is 11 ( I believe it's Heat Down power setting, controlling the power to
maintain the heater at the desired temperature setting (incubating temperature adjust-
ment).
Setting Range 1~80.
- These are settings I have never adjusted or attempted to adjust as the heating
unit starts and stops within 1
8. Display Symbols
Number
Symbol
3.1
AL
(above)
3.2
AH
(above)
4.1
AS
(above)
5.1
CA
(above)
6
HS
(above)
6
LS
(above)
7
HU
(above)
7
HD
(above)
9. Using your Incubator
1. Test your incubator to see if it functions properly.
2.Connect the egg turner plug to the control plug inside the egg compartment.
3. Fill one or both water channels depending on local humidity levels.
4. Set the eggs with the pointy side down.
5. Close the lid and switch on the incubator.
6. Press the reset button (left green button) to reset and start the day counter from "0".
(this will also rest the egg turning countdown back to 1:59)
7. Keep an eye on the humidity reading and fill the water channels when needed.
(normally every 4 days)
8. At day 18 you should remove the tray with the turning mechanism and place the
eggs on top of he bottom grid.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
(HU and HD)
o
C of my set temperature of 37.6
Meaning
Low temperature alarm parameter setting
Higher temperature alarm parameter set-
ting
Low humidity alarm parameter setting
Calibrating the temperature sensor reading
Temperature higher limit set
Temperature lower limit set
Heating starts
Heating stops
o
C.
Factory Setting
o
1
C
o
1
C
45%
o
0
C
o
39.5
C
o
30
C
18
11
Seite 6
Advertisement
Table of Contents
