Instruction; What You Will Find Inside Your Packaging; Key; Testing You Unit For The First Time - WilTec 50036 User Manual

Instruction:

What you will find inside your packaging:

Incubator
Power cord
Instruction booklet

KEY:

1. Testing your unit for the first time.
2. Setting the temperature.
3. Temperature alarm parameter settings (AL and AH)
4. Humidity alarm parameter settings (AS)
5. Calibrating temperature sensor reading (CA)
6. Temperature Upper and lower limit set (HS and LS)
7. Heating Element (HU and HD)
8. Display Symbols
9. Using your incubator

1. Testing you unit for the first time:

1.1 Connect the egg turner plug to the control plug inside the egg compartment.
1.2 Connect the provided power supply to the back of the unit and your power source.
1.3 Switch on your power source.
1.4 Switch your unit on.
1.5 You will hear an alarm sounding due to low temperature/humidity.
1.6 Press any of the green buttons to cancel the alarm.
1.7 By opening the incubator and filling the water channels you will notice the humidity
reading increase.
1.8 Let the unit run for 2 hours to note the egg turner turning.
2. Setting the temperature
2.1 Push "SET" once.
2.2 Push "+" or "-" to select the desired temperature.
2.3 Push "SET" once more to exit.
- These incubators are factory set at 38
20 meaning the temperature being to high. Using the method as described
above. I recommend you set the temperature at 37.6
3. Temperature alarm parameter settings
The temperature alarm is factory set to sound at 1
is sufficient and you do not need to make any changes to these settings.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
o
C, I found the chicks hatch at day 19 to
o
C.
(AL and AH)
o
C over or below the set temperature. This
Seite 4