Installing I/O Module Blanks - Extreme Networks BlackDiamond X8 Installation Manual

7 Use a # 2 Phillips (cross-head) screwdriver to lock each handle into place.
When a locking screw is fully tightened, the yellow band around the screw head is completely
hidden.
Caution
Be careful to avoid over-torquing and stripping the screw heads.
Figure 25: Locking the Module into Place

Installing I/O Module Blanks

Switches are shipped with a reinforcing shipping cover installed over all the I/O module slots. If you
have the older module blanks without thumb levers, see
levers) on page 26.
You need a #2 Phillips screwdriver to install a module blank.
After you have installed all the I/O modules for your system configuration, you must install module
blanks in all remaining unoccupied slots.
Caution
All unoccupied slots in a BlackDiamond X8 series switch must have module blanks correctly
installed to ensure conformance to FCC requirements as well as to maintain adequate airflow
through the switch.
BlackDiamond X8 Installation Manual
Installing BlackDiamond X8 Series Modules
Installing I/O Module Blanks (without thumb
24