Installing Management Modules - Extreme Networks BlackDiamond X8 Installation Manual

b Align and tighten the retaining screws.
Figure 21: Installing a Fan Tray

Installing Management Modules

Slots for management modules are labeled A and B. Install the first management module in slot A.
1 Attach the ESD-preventive wrist strap to your bare wrist.
2 If it is not already connected, connect the metal end to the receptacle between the management
module slots.
3 If necessary, remove the cover from the unoccupied slot.
4 Remove the module from the antistatic packaging.
Caution
To prevent ESD damage, hold the module by the metal rail and front panel only. Never
touch the components on the PCB or the pins on any of the connectors.
5 Verify that the injector/ejector handle is in the open position.
Keep the injector/ejector handle in the open position as you slide the module into the chassis slot.
6 Carefully slide the module into the slot (starting with slot A) until the injector/ejector handle
engages the edge of the chassis and begins to rotate toward the module.
BlackDiamond X8 Installation Manual
Installing BlackDiamond X8 Series Modules
20