Installing Power Supplies - Extreme Networks BlackDiamond X8 Installation Manual

Figure 11: Grounding Pad on the Chassis
1 = Grounding pad
2 Strip 0.5 inch (1.2 cm) of insulation from the stranded copper wire cable.
3 Insert the stripped wire into the cable lug.
4 Crimp the lug securely onto the cable.
5 Insert the screws through the lug and into the grounding pad on the back of the chassis.
6 Connect the other end of the wire to a known reliable earth ground point at your site.
After the chassis is grounded, install two or more power supplies.

Installing Power Supplies

You need the following tools and equipment to install an AC power supply:
•
# 2 Phillips screwdriver.
•
AC power cord rated for 100-120/200-240 VAC.
Warning
Be sure to read
An AC power cord is not included with the chassis. You must obtain a power supply cord that meets
the requirements listed under
1 Remove the power supply ventilation cover.
a Loosen the retaining screws at the top corners of the cover panel.
b Pull outward on the retaining screws to tilt the cover panel away from the front of the chassis.
BlackDiamond X8 Installation Manual
Safety Information on page 29 before you begin this procedure.
Selecting Power Supply Cords
Installing a BlackDiamond X8 Series Chassis
on page 33.
11