Subscribe to Our Youtube Channel
Related Manuals for Lippert Solera Slider
Summary of Contents for Lippert Solera Slider
- Page 1 Solera Slider INSTALLATION MANUAL ® Page 1 Rev: 06.16.2016 Solera® Slider Install Manual...
-
Page 2: System And Safety Information
56" to 188" in length and extend up to 58”. The hardware hole pattern is universal and will match most competitive brands, which alleviates the need to patch holes. NOTES: • The Solera Slider® kit comes complete with mounting hardware. • Awning rail not included. •... -
Page 3: Tools Required
Prior to Installation Tools Required • Cordless or power screw gun • 5/16" socket • Square drill bit • Butyl tape • Tape measure Resources Required • Two People Installation NOTE: All screws/rivets supporting the awning assembly MUST have a backer within the structure of the wall of the coach. - Page 4 Slide hex rod into roll bar arm and align the screw holes (Fig. 3A). Slide end cap into other end of roll bar arm and align all three screw holes. Fasten using self-tapping screws (Fig. 3B). 10. Apply butyl tape to bracket screw holes so that the butyl tape is against the coach when mounting bracket (Fig.
-
Page 5: Securing The Fabric
16. Secure the second hex rod to the roller bar assembly. 17. Center the Solera® Slider over the slide room using a tape measure. 18. Fasten the hex rods to the brackets using two 5/16" hex head screws in each bracket (Fig. 7). 19. - Page 6 SOLERA® SLIDER ASSEMBLIES A. Complete Solera® Sliders include fabric, roll bar, drive head assembly and idler head assembly. B. Length of Solera® Sliders is measured from center of torsion bar to center of torsion bar and hardware can be adjusted to fit multiple widths. C.
- Page 7 SOLERA® SLIDERS FABRIC ONLY All Solera® Slider fabric produced prior to August 2014 will have a projection of 58". All fabric produced after that date will have a projection of 50". B. All fabric will be 5" shorter than the Solera® Slider length on order. Solera®...
- Page 8 SOLERA® SLIDER HEAD ASSEMBLIES Callout White Part # Black Part # Description 272455 285149 Drive Head Assembly 272454 285148 Idler Head Assembly Page 8 Rev: 06.16.2016 Solera® Slider Install Manual...
- Page 9 Screw #10 - 13 x 1 ¼ csk zn sqd Variant Code Information The variant code on Lippert products can assist LCI customers in obtaining additional information about the product and its components. On the Solera® Slider, the label will be located on the fabric portion of the assembly.
- Page 10 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Solera Slider and is the answer not in the manual?
Questions and answers