Disassembly Procedures; Standard Satellite Array Procedures; Gemstone Satellite Array Procedures - Bose 3-2-1GS Series II Service Manual

Standard Satellite Array Procedures

Notes:
The standard satellite arrays are non-
•
repairable. These are the arrays that have
the cloth grilles, and are physically larger
than the Gemstone
The only parts that can be replaced on the
•
standard arrays are the grille and the name-
plate. Refer to the photos at right for the
following procedures.
1. Grille Removal
1.1 Wrap some masking tape around the
shaft of a flat-tip screwdriver approximately
1/2" back from the end. This is needed to
protect the plastic enclosure of the array.
1.2 Place the satellite array on its back on a
bench. Use your thumb to press down on
the array grille at the center of the curve
near the side. At the same time, use the
screwdriver to pry the end of the grille off of
the array enclosure. Repeat this at the other
end of the grille.
Re-Assembly Note: Align the grille so that
the Bose logo is facing the same direction
®
as the arrows on the front of the array
enclosure. Press the grille in place. It should
latch to the enclosure at each end.

Gemstone Satellite Array Procedures

1. Grille Removal
1.1 Using a scribe or small flat-tip screw-
driver, grasp the edge of the grille. Gently
pull the grille away from the enclosure.
2. Driver Removal
2.1 Perform procedure 1.
2.2 Using a Phillips-head screwdriver,
remove the four screws that secure the
driver to the enclosure. Lift the driver out of
the enclosure and cut the wires as close to
the driver as possible.

DISASSEMBLY PROCEDURES

array.
TM
53