Table of Contents
Advertisement
Symptom
Windows 95/98 locks up after installing PCI card.
The system tray wireless monitor is always red.
If you cannot connect to one of the clients in the
network.
The NT event log lists the error: "Server Service
terminated. Not enough Server Storage."
In Windows NT, there is no wireless monitor icon in
the taskbar or the Samsung Adapter does not
appear in the PC Card Control Panel applet.
Solving Problems
Diagnosis
The installation procedures may not have been
followed exactly. Turn off your PC and remove
the PCI card. Restart your PC and run the
installation program again as instructed in the
installation guide.
Make sure that all the clients have the same SSID.
Set all clients to the same wireless channel in case
of Ad-hoc network mode.
Make it sure that you are with in the range of an
Access Point (AP). If your PC can't be associated
with any AP, it cannot communicate with other
clients.
Make it sure that all clients are up and are running
with a blue taskbar icon.
Make it sure that the client that you want to
communicate with is within the range of an AP.
Make sure that your TCP/IP is set properly and
correctly.
Reinstall the Windows NT service pack.
Make sure the PCMCIA device is started as
Automatic in the device applet of the Control
Panel.
Double click on the PC Card icon in Control Panel.
Click on Samsung Adapter and then on the
properties button. It should say the driver started
correctly.
Make sure the drivers were installed correctly. If all
else fails, uninstall drivers and software through
Add/Remove Program, remove the WLAN Card
and reinstall the drivers following the manual.
29
Advertisement
Table of Contents
