Table of Contents
Advertisement
In network setup wizard box, click on select from list button.
7. In Select Network Adapter box click on Have Disk button.
8. In Insert Disk box, you may be asked to specify the necessary software directory.
Insert the MagicLAN Installation CD into the CD-ROM drive. Type in D:\nt40
(Where D is the CD-drive of your Notebook) in the blank and click on OK.
9. In Select OEM Option box, we will see Samsung 11Mbps Wireless LAN Card
and click on OK.
10. We confirm the Samsung 11Mbps Wireless LAN Card.
11. Select the network protocols by clicking on the Protocols. And click on TCP/IP.
12. In the next box to choose network services to use, make sure that all the services you
want to use are checked and click on Next.
13. In the next box it is confirmed that necessary NT networking components are selected.
Click on Next. When you are asked to specify the directory that the necessary NT
files are copied from, insert your Windows NT CD and type in D:\i386 in the
location blank.
14. Some files from the D:\i386 directory are copied and you may be prompted the same
box to ask you to specify where NT files are once more.
15. Since it is looking for some files form the installation CD, insert your installation CD
in CD drive and type D:\nt40 in the blank location and click on continue.
16. Configure Wireless LAN Card box may appear. Set each parameter (I/O base,
Interrupt) for the proper system configuration set up and other parameters (network
mode, ESS ID, and Tx rate) for the proper LAN card configuration.
17. TCP/IP installation message will pop up. Select NO for DHCP.
18. If you select the DHCP option for TCP/IP, you do not need to set the values. If you
select the Static, enter the IP value, Subnet masking, Gateway, and DNS values
respectively and then click on OK.
19. Binding properties will pop up. Click on NEXT.
20. Add the services that you want to avail. You can add other protocols such as
NetBEUI.
21. Now it is ready for installing networking. Click on NEXT.
22. Networking is confirmed. Click on NEXT.
23. You can assign Workgroup/ Domain name. And click on NEXT.
24. Click on the Finish and it will ask you whether you want to restart your computer or
not. Click on Yes.
25. If your PCI card is not detected or not functioning properly, please refer to
Troubleshooting at the end of the manual.
When Windows NT networking is already installed:
18
Advertisement
Table of Contents
