Advertisement
Digital Access Keypad Manual
Page 4
5HOD\
5HOD\
2))
21
$/
.(<
SECO-LARM U.S.A., Inc.
PREPARING TO PROGRAM THE KEYPAD
To program the SK-1131-SQ, first determine the following information:
1. The master code -- Allows the system administrator to program or operate the keypad.
2. The user code or codes -- Allows users to use the keypad's functions.
3. Configuration of the relays and outputs -- For relay output #1, relay output #2, and output #3,
determine whether the output should operate from 1 to 999 seconds and then turn OFF (momentary
mode), or turn ON/OFF via the code (shunt mode).
4. Result of improper code entry -- Choose between a 30-second code lockout, duress output, a 15-
minute code lockout, or no reaction.
* Note: When
appears in the instructions, it indicates master code entry.
X X X X
GETTING STARTED
A master code is required to program the keypad. The default master code is set to "0000." To change the
master code, go to page 15 and follow the instructions for "MASTER CODE BYPASS (DAP jumper).
Once the master code is set, review the programming options and decide exactly what the keypad will do,
including the format of the user access codes as well as how the keypad responds via the relay output,
buzzer and LEDs. Note that in every case the basic steps for programming are:
1. Enter the master code, followed by the
*
2. Enter the programming codes defined in the various sections as needed, followed by the
3. Enter the
key again to exit programming mode.
*
Note: A rapid string of 5 beeps and/or 5 LED flashes indicates an error, while 2 beeps indicates that the
entry has been accepted.
USER PROGRAMMING
ENTER PROGRAMMING MODE
Enter Master code
Confirm
X X X X
*
Note: For first-time use, Master code is
.
0 0 0 0
ADDING OR CHANGING MASTER AND USER CODES
User ID
Access code
Option
Confirm
4 to 8 digits
0
#
00 to 99
4 to 8 digits
1
#
2
0 to 9
4 to 8 digits
#
3
0 to 9
4 to 8 digits
#
Note: No user code may be the same as the master code.
Note: For User ID, key in the number of the user. For Access Code, type in the code for that particular user.
DELETE A USER
To delete a user who has left the company or who no longer has authority to enter the protected area:
1. Enter programming mode:
Enter Master code
Confirm
*
X X X X
2. Delete code:
Function
Option
Confirm
User ID
Deletes specific user ID from output #1
1
#
00 to 99
Deletes specific user ID from output #2
2
#
0 to 9
3
Deletes specific user ID from output #3
#
0 to 9
EXIT THE PROGRAMMING MODE BY PRESSING THE "
Digital Access Keypad Manual
key, which puts you in programming mode.
Function
Enter into programming mode
Function
Master Code
Up to 100 User Codes for relay output #1, with duress feature
Up to 10 User Codes for relay output #2
Up to 10 User Codes for output #3
Function
Enter into programming mode
*
" KEY
key.
#
Page 13
Advertisement
