Kenmore 625.34842 Owner's Manual page 53

Demand special edition water softener
Table of Contents

Advertisement

SECTION 5
SERVICE TECH. INFORMATION
I
I
5A.
TROU B LES H OOTI N G
CORRECT
SWITCH
DISPLAYS
-p
VALVE CYCLE STATUS
Valve in service, fill, brining, back-
wash or fast rinse position
Valve rotating from one position to
another
While in this diagnostic
screen, the following
in-
formation
is available
and may be beneficial
for
various
reasons.
This information
is retained
by
the computer
from the first time electrical
power
is applied
to the face plate.
-- Press
[_
to display
the number
of days
this
face plate
has had electrical
power
applied.
-- Press
[_ to display
the number
of regenera-
tions initiated
by this face plate since
the SR code
number
was entered.
°
Press the SELECT button
and hold 3 seconds
un-
til...
J
CODE
I
SR 17
shows.
_
|
|
This code
identifies
the softener
nominal
capacity
size.
If the wrong
number
shows,
the softener
will
operate
on incorrect
programming.
Do the following
as needed.
Return
the
present
time
display:
Press
the
SELECT button.
Change
the SR number:
To display
the correct
SR
number,
press
the{_UP
or DOWN
{_ button.
Press
SELECT, and reset the tim_ _
NOTE:
If the face plate is left in a diagnostic display (or a
flashing display when setting times or hardness),
present time automatically
returns if a button is not
pressed within 4 minutes.
FACE PLATE REPLACEMENT:
Be sure
the valve
is
in service
position
(observe
valve
cycle
indica-
tor) when
replacing
the face plate.
/flO
If, after installing
and programming
the replace-
ment face plate, the valve is not in service position,
do the following to assure correct cycle orientation,
or timing, between
the face plate and valve.
Use the MANUAL ADVANCE procedures,
page 22.
With
the
RECHARGE
NOW
button,
advance
through
the recharge
cycles until the valve stops in
service
position,
and RECHARGE
no longer
flashes
in the timer.
NOTE: The valve motor may automatically
drive
through several valve positions while searching for
service. If an error code occurs, unplug the trans-
former, then plug in again.
CAM
/,
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

625.348420

Table of Contents