Check List Of Step-By-Step - Kenmore 625.34842 Owner's Manual

SECTION 1 WATER SOFTENER START-UP
I I
lB. CHECK LIST OF ALL STEP-BY-STEP GUIDES TO INSTALL
Refer to the Installation Manual, part no. 7159931, for
step-by-step guMes.
To be sure you have done all the steps to install the
softener, read the following list. Page numbers
referred to are in the Installation Manual
_/' Is the house water supply flow going into the
softener valve INLET? Trace piping to be sure.
See pages 10 and 11.
_/' Is the plumbing bypass valve (or 3 valves) set for
soft water service? See page 18.
v'
Is the valve drain hose connected to the drain fit-
ting the right way? Does the drain hose run
tO
the
drain point without sharp bends or kinks that
could stop or reduce water flow? See page 16.
,/
Is the softener power cable connected to the
transformer, and is the transformer plugged into
an inside, ] 20V-60Hz electrical outlet? See page
20.
_/' Be sure to restart the water heater. See page 20.
brass
Valves
plastic
NOTE: The state of Massachusetts requires a licensed
plumber to perfk)rm the installation.
Water
Heater
5