Program - Kenmore 625.34842 Owner's Manual

SECTION 1 WATER SOFTENER START-UP
! !
lC. PROGRAM THE TIMER
DOWN
display UP button button
\ \ /
Se°rsW°terL'°e [ ] ( V_" Kenmore
for CustomerAssistance
1-800-426-9345
DemandWaterSoftener
_ RECHARGE TONIGHT
RECHARGE NOW
J
SEL EC T button
ON/OFF-HOLD button
(Recharge Tonight-Now)
When the transformer is plugged in, the model code
SR]7 shows in the face plate display for a few
seconds, followed by a test number (example: $3.0).
After the test number, ]2:00 AM begins to flash.
PRESENT TIME and RECHARGE TONIGHT show at
the bottom of the display.
CODE
]
I
_RESENT TIME
NOTE:
If SR - - is flashing in the display, press the UP [_
button (FIG. 1) until SR]7 shows. Then, press the
SELECT button to display the flashing 12:00 AM. If
other than SR17 shows, when the transformer is
plugged in, please see page 1"7to reset.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for timer set-up. One beep signals a
change in the face plate display. Repeated beeps
means the timer will not accept a change from the
button you have pressed, telling you to use another
button. For example, in setting the hardness (step 2),
the beeper sounds repeatedly when the display
reaches 1 using the DOWN button, or the highest
hardness setting using the UP button.
1. SET PRESENT TIME OF DAY:
NOTE:
If the words PRESENT TIME do not show in the dis-
play, press the SELECT button (FIG. 1) until they do.
• Press the [_ UP/DOWN {_ buttons to set the
present time. Press UP to move the display ahead;
press DOWN
tO
move the time backward.
If the present time is between
noon
and midnight, be sure PM shows.
If the present time is between
midnight and noon, be sure AM
shows.
PRESENT TIME
I
'RESENT TIME
NOTE:
Each press of the UP or DOWN buttons changes
the
time by ] minute. Pressing and hoMing the buttons
changes the time 32 minutes each second.
6