Kenmore 625.34842 Owner's Manual page 25

SECTION 5
SERVICE TECH. INFORMATION
I I
5C. WATER FLOW THROUGH THE SOFTENER VALVE
BRINING AND BRINE RINSE CYCLES
venturi
drain
e/e
brine from salt "
storage tank
bypass
hard water
to valve
outlet
from Valve Inlet
(hard water)
After fill,
timer/switch
action allows the
motor to turn
the rotor and disc into BRINING
position. Water flow is directed to the nozzle. Suction, created by the nozzle and venturi,
draws brine from the salt storage tank and injects it into the resin bed via the bottom
distributor. Flow continues out the top distributor and to the drain. Hard water is available
at the valve outlet.
When the brine valve closes
to
end brine draw, water flow continues in the same
directions to slowly RINSE brine from the resin bed and to the drain.
bypass
hard water
to valve
outlet
f
BACKWASH CYCLE
flow plug
drain
Timer/switch action again allows the motor to turn the
rotor & disc to place the valve in BACKWASH, stopping
water flow to the nozzle. Water is routed down and out the
bottom distributor, up through the bed, and out the top
distributor to the drain. The fast flow (controlled by a flow
plug in the drain fitting) flushes dirt, sediments, iron
deposits, remaining brine and hardness to the drain.
I
\
b,
25