Table of Contents
Advertisement
operating convenience. Using the surface
base as a guide, mark four holes on the
transmission hump or other selected location.
The four mounting tabs on the surface base
are somewhat flexible to conform to a curved
surface as necessary.
Step 2 Using an awl or similar device, open four
holes in the carpet at marked locations. This
must be done prior to drilling to avoid ruining
the carpet.
Step 3 Using a 3.2 mm (1/8") bit, drill the four
mounting holes and secure the surface base
using the four 8-1/8 x 3/4" tapping screws
provided.
Step 4 Mount the base to the surface base at the
desired angle and securely tighten the angle-
adjusting screws.
Installation Manual
31
Advertisement
Table of Contents
