Secure the Unit
To secure the unit in your vehicle, run a standard lap
belt through the loop located on the outside of the
carry case as shown in Figure 9.
Disassembly
If you wish to remove the handset and transceiver
from the Attache accessory for servicing, or to place
them in a vehicle equipped with a permanent mobile
installation, use the following procedure.
Step 1 Turn the unit off by pressing ∏ on the handset.
Step 2 Unplug the handset from the modular
connector jack on the side of the transceiver
and remove it from the hang-up cup.
Step 3 Unzip the transceiver compartment and
carefully lift the transceiver/connector
assembly out of the pocket.
Step 4 Unscrew and remove the antenna.
Installation Manual
Figure 9
9