Listening To Tape - Sanyo MCD-Z260F Instruction Manual

TURNING TO FM STEREO STATIONS
To receive an FM stereo broadcast, make sure that
"MONO is not displayed. If "MONO appears,
press [REPEAT/FM MODE] to turn "MONO off.
"ST" appears when an FM stereo broadcast is re- .
ceived.
If the signal from an FM stereo station is weak
and reception is poor, press [REPEAT/FM MODE]
to change to monaural reception. "MONO ap-
pears. The sound will be monaural.
PROGRAMMED TUNING
If a station frequency is stored in the memory, it
can easily be recalled using [P,SCAN].
Up to 6 stations each can be programmed in the
FM and AM bands.
Programming stations
1. Tune in the station to be preset as described
in "UP/DOWN TUNING.
2. Press [MEMORY]. "PRG blinks.
3. While "PRG" is blinking, press [P.SCAN] to
select the channel number (1-6) to be preset.
4. While '(PRG" is blinking, press [MEMORY].
5. Repeat the steps above to add more program-
ming stations.
NOTE:
Whenever a new station is programmed, the
previous programming will be canceled.
TUNING INTO PROGRAMMED STATIONS
Preset scan tuning
1.
Press [BAND] to select the desired band.
2. Press and hold down [P.SCAN] for at least 1
second. '(PS" blinks.
The programmed stations are tuned into suc-
cessively for about 5 seconds each.
3. If [P.SCAN] is pressed within about 5 seconds
when a desired station has been tuned in to,
that station will stay tuned in to.
LISTENING TO TAPE
NOTES:
Do not use the endless tape.
Use the normal tape (TYPE 1)
PLAYBACK
1. Set [FUNCTION] to TAPE.
2. Press [STOP/EJECT].
The cassette holder opens.
3. Load the cassette into the cassette holder.
4, Close the cassette holder.
5. Press [PLAY].
6. Adjust
[VOLUME],
[TONE] and
[BASSXPANDER] as desired.
7. Press [STOP/EJECTl to stop playback at any
time. When the end of the tape has been
reached, automatic stop will be activated.
Pause
Press [PAUSE] to temporarily stop the tape dur-
ing playback or recording. Press it again to con-
tinue.
Fast Forward and Rewind
Press [FFWD] or [REW] to quickly wind the tape
forward or backward. Press [STOP/EJECTl to stop
the tape.
When the end of the tape is reached, the tape will
stop, and [FFWD] or [REW] will be automatically
released.
Full automatic stop
This unit has a full-release stop system, to protect
the tape and prevent pinch roller damage. When
the end of the tape is reached in Playback, Re-
cording, Fast forward or Rewind, the tape mecha-
nism will automatically stop.
Alternate tuning method
1. Press [BAND] to select the desired band.
2. Press [P.SCAN] to display the number of the
preset of your choice.
Tap [P.SCAN] lightly.
9