After Installation - Electrolux MCD3880EM User Manual

• DO NOT USE THE OVEN if the power cable or the plug are damaged, if the oven does not
function correctly or if it has been damaged or dropped. Contact the Technical Assistance
Service.
• Put the oven on a flat and stable surface. The oven must not be installed close to any
sources of heat, radios or televisions.
• During installation, make sure that the power cable does not come into contact with
any moisture or objects with sharp edges behind the oven. High temperatures can dam-
age the cable.
WARNING!
after the oven is installed you must make sure you can access the plug.

After installation

• The oven is equipped with a power cable and a plug for single phase current.
• If the oven is to be installed on a permanent basis it should be installed by a qualified
technician. In such a case, the oven should be connected to a circuit with an all-pole
circuit breaker with a minimum separation of 3 mm between contacts.
WARNING!
THE OVEN MUST BE EARTHED.
• The manufacturer and retailers do not accept responsibility for any damage that may be
caused to people, animals or property if these installation instructions are not observed.
• The oven only functions when the door is closed correctly.
• After the first use, clean the inside of the oven and the accessories, following the cleaning
instructions given in the section 'Maintenance and cleaning'.
Fit the Turntable support (1) in the centre of the oven cavity and put the Turntable ring (2)
and the Turntable plate (3) on top, making sure they slot in. Whenever you use the micro-
wave, the turntable plate and the respective accessories must be inside and correctly fitted.
The turntable plate can rotate in both directions.
3
2
1
25
Installation