Attaching An Optional; Operating Instructions; Power On The System; Normal Operation - General DCS1100 User Manual

ATTACHING AN OPTIONAL HIGH-PERFORMANCE PROBE
To replace the included front/side view probe with another compatible high-
performance probe from General, first detach the front/side view probe from
the handle by turning its collar counterclockwise and pulling the probe straight
out and away.
To attach the new probe, plug its connector into the handle's probe socket. The
probe and the handle mate in only one way: when the red dot under the collar
on the end of the probe is aligned with the flat on the probe socket. After
orienting the new probe, push its connector into the socket and tighten the
collar by turning it clockwise.
Whether you use the included probe or an optional probe, remember to remove
the protective rubber cap from its camera end before using it.

OPERATING INSTRUCTIONS

POWER ON THE SYSTEM

To power on the DCS1100, press the
black rubber button with the icon on
the top of the grip and hold it for five
seconds. A green light at the bottom of
the button will illuminate. The word
"READY" will appear inside a box in the middle of the display.
At the upper right of the display a green icon indicating the level of
battery charge will appear.
(To power off the DCS1100, press the button and hold it for five seconds
until the green light at the bottom of the button extinguishes.)

NORMAL OPERATION

To use the DCS1100, point the camera end of the probe at the area or object of
interest. Live video will appear on the display.
To change the view of the front/side view probe, toggle the view switch
(see Figure 2).
To change the brightness of the display, press the or button repeatedly
until the screen is at the optimum brightness for your environment. Each click
of the buttons increases or decreases the brightness by one step. Maximum
brightness is indicated by a "15" at the bottom of the screen. Minimum
brightness is indicated by a "0".
7