Advertisement
OPERATI
DISCHARGE
DEFLECTOR
AUGER
DRIVE
CHUTE
REMOTE
GASOLINE
CONTROL
SPEED
CONTROL
CONTROL
FILLER CAP
LEVER
CONTROL
LEVER
LEVER
ELECTRIC
LEVER
MUFFLER
START
BUTTON
CHUTE
RECOIL
DEFLECTOR
TRACTION
DRIVE
CHOKE
STARTER
CONTROL
CONTROL
HANDLE
LEVER
PRIMER
=H TURN
TRIGGER
SAFETY
iGNiTiON
KEY
NOTE: iTEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE,
ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT,
THROTTLE
DISCHARGE
CHUTE
ON/OFF
SWITCH
CLEAN=OUT
TOOL
HANDLE
KNOB
MUFFLER
TOOLBOX
P LATE
AUGERS
FIG, 10
MEETS A.N.SJ. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards institute.
Toolbox - used to store spare shear bolts, Iocknuts and
wrench.
Safety ignition key = must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary)
starter handle - used for starting the
engine.
LH and RH turn triggers =used to steer the snow thrower.
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Primer = pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
ON / OFF switch - used to STOP the engine.
10
Choke control = used for starting a cold engine.
Throttle= used to select FAST or SLOW engine speeds.
Traction drive control lever - used to engage power-pro-
pelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Deflector remote
control lever = used to change the
distance the snow is thrown.
Discharge
chute control lever = used to change the di-
rection the snow is thrown.
Skid plate = used to adjust height of scraper bar from the
ground.
Advertisement
