Kenmore 385.1915 Owner's Manual page 68

Set the Machine
_] [_ B,t Foot,. j_
Thread tension
2to6
N: Automatic buttonhole foot
_ULLLj =rE:> B,2 FOOT N
Rounded
=L=0B,3Foot,!
The machine sews three different types of
buttonhole to meet every sewing need. AIt
three buttonholes are made in the same way.
The automatic buttonhole foot will gauge
the buttonhole length.
Before you sew buttonholes on the actual
garment, make several practice button-
holes on a scrap of the same fabric.
66
. a. Press the Up!Down Needle Position
Button to raise the needle to its
highest position,
b. Raise the presser foot,
c. Remove the foot holder.
d. Attach the automatic buttonhole
foot by tightening the foot holder
screw.
Thickness
Oiameter
,1%,, _
L_]-- easu,o
2.5 cm {31/32"1
Buttonholder
2. a. Draw both threads toward the left under the foot,
b. Lower the needle to the bottom mark.
c. Lower thepresser foot.
d. Open the button holder by pulling it back as shown above.
e, Place the button you intend to use on the button holder of the
automatic buttonhole foot N.
f. Press the back of the holder towards you to secure the button.
NOTE: If the thickness of button is more than 0.4 cm (3/16"),
measure thickness end diameter and set the button holder as
shown.
EXAMPLE: If the button is 2 cm (3/4") in diameter and 0.5 cm
(3/16") in thickness, set the measure 2,5 cm (31/32"),
Add thickness and diameter. And use the sum for the
setting,