VASTEX Screen Drying Cabinet is intended for the drying of emulsion on screen printing screens. Do not use for any other purpose unless authorized by Vastex International, Inc. Use of this equipment for any other purpose can be dangerous and may cause damage to this equipment voiding the warranty.
Assembly 1) Unpack your drying cabinet and remove the (4) lag screws (with a 7/16 socket) holding it down to the skid. Open the doors and remove the Shelves, the Center Tree (Wide Dri-Vault only), and any oth- er items inside. 2) Slide the drying cabinet to the edge of the skid and install the (4) casters or levelers at each corner of the machine.
Breaker Switch is used to turn the machine on and off. In the event of a short or electrical failure, the switch will trip into the middle position. If the breaker will not reset, or it trips often, contact Vastex tech support or a li- censed electrician.
Page 5
Controls Cont. 1) Automatic Tuning has been performed at factory for all 240v machines. Automatic Tuning must be performed by the customer for the following reasons. When equipment is other than 240v (e.g. 208v), replacing a controller, replacing a “J” sensor, and/or new heating elements. Control- ler set point value must be set to 100 Degrees Fahrenheit before beginning auto-tuning.
The filter should be replaced as necessary. Filter material can be ordered through Vastex. 2) It is important that the inside of the dry cabinet is keep clean. Periodic cleaning of the in- side of the cabinet is recommended.
Check connections Customer power failed or outlet failed Check power at main disconnect Circuit breaker switch trips to center position Internal fault - contact Vastex Main Power Pilot Light lit: Temperature control knob set to “OFF” Set temperature control knob VDC-253610 &...
The defective part or parts will be repaired or replaced at the discretion of Vastex International, Inc. If the equipment in question is less than one (1) year old, it will be shipped to the customer at no charge, with an RGA issued by Vastex for the defective part. The defective part must be shipped back to Vastex freight prepaid within 30 days or the account will be billed.