Samsung MWR-WE11N Installation Manual page 6

Wired Remote Controller Installation
Wired Remote Controller Installation
3. Using more than two screws, firmly affix the rear cover of the remote controller to the wall, and then connect
the communication & power cable[(F3,F4) or (3, 4)], making sure these cables have reasonable length,
to the terminal at the back of the cover.
10 mm(0.4 inch) or more
10 mm(0.4 inch) or more
10 mm(0.4 inch)
or more
50 mm(2 inch) or more
10 mm(0.4 inch) space of upper side, left side,
right side, and 50 mm(2 inch) space
of bottom side.
4. Reassemble your Wired Remote Controller.
shown in the figure.
When installing a Wired Remote Controller by using a cable longer than 10 m(32.80 ft), you must install the
communication cable and the power cable separately. (Electrical interference can cause your Wired Remote Controller
to malfunction.)
a proper thickness.
- If you install the Wired Remote Controller by reclaiming, install it according to U-terminal cable specification.
greater, it may damage the screw thread.
6
Screw hole
You must fit the screws into
the screw holes.
Range of Permitted Wires
E
W Stud
D
F G
L
t
Do not tighten the screws on the
Rated Stud
Size Size
2 2
mm mm mm
AWG t
2 2
(inch ) (inch ) (inch)
0.25~1.65
1.5 3 0.7
22~16 (0.0003 ~
(0.0023) (0.1181) (0.0275)
0.0025)
Maximum distance for connecting communication and
power cable: 100 m(3.280 ft)
Indoor unit
Wire (not supplied)
Wired Remote
Controller
Basic Size [mm (inch)]
øD G E F W L
3.8 10.0 4.5 6.5 6.0 21.2
(0.1496) (0.3937) (0.1771) (0.2559) (0.2362) (0.8346)