Craftsman 113.244501 Owner's Manual page 7

C
ITEM
=
A
B
C
D
TABLE OF LOOSE PARTS QTY.
Basic saw assembly ............................ 1
Owners Manual ..................................... 1
Saw Table ........................................... t
Loose Parts Bag
Containing the following parts:
Key Switch ......................................... 1
Wing Nut t/4-20 x 5/8 .......................... 1
Screw, Truss Hdo 1/4-20 .................. 1
Wrench, Hex "L" 1/8 ......................... 1
Bevel Indicator
....................................
1
Screw, Pan Cross 10-32 x 3/8 ............ 1
Washer 17/64 x 1 x 1/16 ..................... 1
Bolt, Carriage I/4-20 x 1.................... 1
Knob ...................................................... 1
Clip Hose .............................................. 1
assernbBy
MOUNTING BAND SAW TO WORKBENCH
If band saw is to be used in a permanent location, it
should be fastened securely to a firm supporting sur-
face such as a workbench
If mounting to a workbench, holes should be drilled
through supporting surface of the workbench using
dimensions illustrated,
1 Each leg should be bolted securely using 5/16"
diameter machine screws, Iockwashers, and 5/16"
hex nuts (not included)Screw length should be
1-3/4" plus the thickness of the bench top,
2 Locate and mark the holes where band saw is to
be mounted
3 Drill (4) 3/8" diameter holes through workbench,,
4, Place band saw on workbench aligning holes in
feet with holes drilled in workbench
5 Insert all four 5/16" screws and tighten,
NOTE: All bolts should be inserted from the top
tnstall the washers and nuts from the underside of the
bench
3/8" DIAMETER
5"' (4) HOLES
i i i ii 1,1,, , ii ,,11,i,l,ll,llr
CLAMPING BANDSAW TO WORKBENCH
The Band Saw can be clamped directly to a work-
bench LJsing two (2) or more "C" clamps on base of
unit
"C" Clamp
Workbench