Setting The Clock; Sleep Function; Using Microphone - LG LM-V1060 Owner's Manual

Setting the CLOCK

.
1 Press CLOCK.
(If the clock requires setting, press and hold
CLOCK for more than 2 seconds.)
- The hours begin to blink.
2 Select a 24 hour cycle or 12 hour cycle by turning
MULTI JOG.
or
(12HR)
3 Press SET to confirm the selected hour
cycle.
4 Use MULTI JOG. to set the correct hours.
5 Press SET.
6 Use MULTI JOG. to set the correct minutes.
7 Press SET and the correct time is shown on the
display.
8 Press CLOCK at any time briefly to see the time.

Sleep Function

When the sleep timer is used, the power is
automatically turned off after the specified time has
elapsed.
1 To specify the time delay before the power is
turned off, press SLEEP.
In the display window you can see
for about 5 seconds. This means that the system
turns off automatically after 90 minutes.
Each time the button is pressed the time interval
before it turns off is reduced by 10 minutes. i.e.
80...70... etc. Select the desired time to turn off.
2 To check the remaining time until the power is
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until it turns off is
displayed for about 5 seconds.
ote
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel the sleep timer mode
If you wish to stop the function, press the SLEEP
button repeatedly until SLEEP 10 appears, and then
press SLEEP once again while SLEEP 10 is display.

Using Microphone

You can sing to a music source by connecting a
microphone to the unit.
1 Connect your microphone (not supplied) to the
MIC Jack.
2 Play a music you want.
3 Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOLUME KNOB.
For your reference
(24HR)
You can record during using microphone.
Refer to the "Recording" explanation section.
otes
• When not using the microphone, set the MIC
volume knob to minimum or turn off the MIC and
remove the microphone from the MIC socket.
• If the microphone is set too near the speaker, a
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level by using the MIC volume control.
• If sound through the microphone is extremely loud, it
may be distorted. In this case, turn the MIC volume
control toward minimum.
9