Table of Contents
Advertisement
USB direct Recording
Record FM, AM or PORTABLE source to USB
Connect USB to the player before recording.
1. Select a mode (PORTABLE, FM or
AM) in which you want to record:
2. Start the Recording:
3. To stop a Recording:
Record Audio CD source to USB
You can record one desired track or all of the music tracks in Audio CD
to USB.
1. Select the CD function:
2. Select the track:
3. Start the Recording:
4. To stop a Recording:
NOTES :
• Remove USB while recording, the recorded file may not be saved.
• Press USB Rec. on the player or REC on the remote control for longer than 3
seconds, you can select bit rate. Press ./> to select the bit rate and
USB Rec. or REC again to select the recording speed. Press ./> to
select a desired recording speed and USB Rec. or REC again to finish record-
ing.
X 1 SPEED (96kbps, 128kbps, 192kbps, 256kbps)
- You can listen to music while recording it.
(FM, AM, PORTABLE or Audio CD)
X 2 SPEED (Only 96kbps, 128kbps)
- You can just recording the music file. (Only Audio CD)
• When you select CD function, and then press USB Rec. on the player or REC
on the remote control as not selecting any tracks, all music files in CD are
recorded.
• Set programs by using PROGRAM/MEMO and press USB Rec. on the player
or REC on the remote control, you can record desired songs on CD in order.
• When set sleep mode to on, recording stops at the previously set time and
then the player is turned off.
1. Press for at least 2 seconds:
2. Choose from either: AM 12:00 (for an am and pm dis-
ON PLAYER
ON REMOTE
FUNC.
FUNCTION
3. Confirm your selection:
or INPUT
4. Select the hours:
USB Rec.
REC
5. Press:
x x
x x
6. Select the minutes:
7. Press:
Use your player as an alarm clock
ON PLAYER
ON REMOTE
Press and hold TIMER on the player for two seconds. Each function, TUNER,
FUNC.
FUNCTION
CD, USB flashes for two seconds. Press SET on the player when the function
./>
./>
you want to be woken by is showing.
USB Rec.
REC
If you choose TUNER you will be shown the stations you have saved as pre-
sets. Use ./> on the player to select the station you want, then press SET
x x
x x
on the player.
You will be shown the ON TIME display. This is where you set the time you want
the alarm to go off. Use ./> on the player to change the hours and min-
utes and SET on the player to save.
You will then be shown the OFF TIME display. This is where you set the time
you want the function to stop. Use ./> on the player to change the hours
and minutes and press SET on the player to save.
Next you will be shown the volume (VOL) you want to be woken by. Use
./> on the player to change the volume and SET on the player to save.
Switch the system off. The clock icon shows that the alarm is set.
When the system is turned off you can check the time the alarm is set for by
pressing TIMER on the player. You can also turn the alarm on and off by press-
ing TIMER on the player. To set the alarm to go off at a different time, switch the
system on and reprogramme following the same steps as initially.
Setting the Clock
play) or 0:00 (for a 24 hour display)
ON PLAYER
CLOCK
./>
SET
./>
SET
./>
SET
9
Advertisement
Table of Contents
