Troubleshooting - LG LM-V1060 Owner's Manual

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power. • The power cord is disconnected.
No picture. • The TV is not set to receive VCD signal
output.
• The video cable is not connected
securely.
• The connected TV power is turned off.
• The audio cables are not connected
There is no sound or
securely.
only a very low-level
sound is heard.
• The power of the equipment connected
with the audio cable is turned off.
• The audio connecting cord is damaged.
The playback picture
• The disc is dirty.
ispoor.
• The disc is placed upside down.
The unit does not
start playback.
• The disc is not placed within the guide.
• The disc is dirty.
• The plugs and jacks are dirty.
Severe hum or noise
is heard.
• The disc is dirty.
• The speakers and components are
connected poorly.
• The unit is located with TV nearly.
• The components are connected
Recording cannot be
incorrectly.
done.
• The source is selected incorrectly.
• The antennas are connected poorly.
Radio stations
cannot be tuned in.
• The signal strength of the stations is too
The remote control
weak (when tuning in with automatic
does not work
tuning).
properly.
• The remote control is not pointed at the
remote sensor on the unit.
• The remote control is too far from the
unit.
• There is an obstacle in the path of the
remote control and the unit.
• The batteries in the remote control are
exhausted.
Cause
• Plug the power cord into a wall power
• Select the appropriate video input mode
• Connect the video cables into the jacks
• Turn on the TV.
• Insert the audio cable into the jacks
• Turn on the external equipment
• Replace it with new one.
• Clean the disc.
• Place the disc with the playback side
• Place the disc on the disc tray correctly
• Clean the disc.
• Wipe them with a cloth slightly moistened
• Clean the disc.
• Connect the speakers and components
• Move your TV away from the audio
• Connect the components correctly.
• Select the source with the FUNCTION
• Connect the antenna securely.
• Adjust the antennas and connect an
• Tune in the station manually.
• Point the remote control at the remote
• Operate the remote control within about
• Remove the obstacle.
• Replace the batteries with new ones
Possible Solution
outlet securely..
on the TV so the picture from the unit
appears on the TV screen.
securely.
securely.
connected with the audio cable.
down.
inside the guide.
with alcohol.
securely.
components.
SELECT button (CD/VCD, TAPE, AUX or
TUNER).
external antenna if necessary.
sensor on the unit.
23 ft (7 m).
21