Appendix 3: Factory Default Settings - Accumet AP84 Operating Instructions Manual

15. Appendix 3: Factory Default Settings

Resetting the meter to factory default settings clears all calibration data and returns
other setup functions to the default settings shown in the table below. However, the
following settings will remain as you have set them:
• temperature unit of measure (°C or °F)
• The temperature offset calibration value
• the LCD contrast setting
See pages 38, 46 and 55 for directions on setting all modes of this meter to factory
default settings.
Program Function
Clr Memory clear
dPr Pressure units
Barometric pressure
Salinity adjustment
OFS Set % saturation offset
CAL View calibration data
ELE View pH electrode offset
View pH electrode slope
View DO probe slope
View % saturation offset
View mV value of DO probe
@ 100% saturation
View mV value of DO probe
@ 0% saturation
COF Ready indicator/auto endpoint
Select mg/l or ppm units
Select temperature units
LCd Adjust backlit display
rST Reset to factory default
Options/settings
yes/no
Hg or Pa
adjust from 500-1499 mm Hg
adjust from 0-50 ppt
up to ±10%
—
—
—
—
—
—
—
on/off
mg/l or ppm
°C or °F
levels 0 to 8 (brightest)
yes/no
Default
no
Hg
760 mm Hg
0 ppt
no offset
– – –
0.00 mV
100.0%
1.000
0 % offset
37.0 mV
0.3 mV
Ready on only
mg/l
retains settings
8
no
65