•
Move Run/Stop switch to the "Run" position.
•
Pressthe primerbulb three (3) times, waiting two
(2) secondsbetween each push.
•
Grasp starter handle and pull slowly untilyou feel
some resistance.Then pull cord rapidlyto
overcomecompression,prevent kickbackand start
the engine. Let rope retum to starter slowly.
Note: The Pressure Command
TM
may be placed in
any positionduring staring or operation.However, for
cold starts, it is recommendedthat the Pressure
Command
TM
be placed in the Uhigh"position.
Note: If the engine fails to start after 3 pulls, primethe
engine three (3) times and pull starter rope again.
Once the engine has started, disengage the spray
gun safety latch.
HOW TO STOP YOUR CLEANING
SYSTEM
•
Move the Run/Stop switch to the "Stop" position.
Simply shutting off the engine will not release
pressure in the system. Squeeze trigger on the
spray gun to relieve pressure in the hose.
Note: A small amount of water will squirt out when
you release the pressure.
•
Rotate the Dial-A-Cleaner
TM
selector knob to the
OFF position to prevent chemical leakage.
SIPHONING
DO NOT siphon standing water for yourwater supply.
Contaminated, brackish or dirty water can damage the
pump. Connect only to householdwater supply.
TIPS
Never use the garden hose inlet to siphon
detergent or wax.
If you hold the spray nozzle too far away from the
object being cleaned, washing will not be as
_'
effective.
•
Always store the cleaning system with the Dial-
A-Cleaner
TM
selector knob to the OFF position.