Replacing The Display Assembly; Procedure - Dell Inspiron 5482 Service Manual

Identifier
Status
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Identifier
Status

Procedure

CAUTION: Place the computer on a soft and clean surface to avoid scratching the display.
1 Align the screw holes on the display assembly with the screw holes on the palm-rest and keyboard assembly.
2 Replace the six screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
3 Route the antenna cables through the routing guides on the palm-rest and keyboard assembly.
4 Close the display, and turn the computer over.
5 Connect the fan cable to the system board.
6 Adhere the tape that secures the fan cable to the system board.
7 Slide the I/O cable into the slot on the system board and close the latches to secure the cable.
8 Slide the touchscreen cable into the slot on the system board and close the latch to secure the cable.
9 Slide the display cable into the slot on the system board and close the latch to secure the cable.
10 Adhere the tape that secures the touchscreen cable to the system board.
11 Adhere the tape that secures the display cable to the system board.
GUID-2DF70EB1-9D26-4051-8B7C-FB14A89925D8
Released

Replacing the display assembly

computer. After working inside your computer, follow the instructions in
GUID-224E829B-C8F4-43FE-AEE6-7C15EC752832
Released
After working inside
www.dell.com/
Replacing the display assembly
31
53