Table of Contents
Advertisement
Overview
OPT-SW-LM-MS (V2.9)
Note:
Unless otherwise noted in this manual, "Control Panel" equally applies to
either the OGCP-9000 Remote Control Panel rack-mount unit or the Win-
OGCP PC-based application.
This manual supplement provides descriptions and overviews, installation,
setup, and operating instructions for the Audio Loudness Meter option (+LM).
This option is installed as a software upgrade to any of several Fusion3G
®
COMPASS
cards and the OGCP-9000 Remote Control Panel or WinOGCP.
As such, with the option installed on a Fusion3G
(hereinafter referred to as "host card") and the Control Panel, the option
provides an audio loudness meter function as described in this supplement.
Note that the host card and Control Panel retain all of their normal functions;
the Audio Loudness Meter functions are available as seamlessly added
submenu selections on the Control Panel.
Note:
Host card(s) and control panel(s) use separate option licensing as shown
below.
This manual supplement consists of the following chapters:
•
Chapter 1, "Introduction" – Provides information about this manual
and what is covered. Also provides general information regarding the
Audio Loudness Meter option.
•
Chapter 2, "Option Installation" – Provides instructions for
installing and configuring the Audio Loudness Meter option ("+LM")
on the Control Panel and host card(s).
AUDIO LOUDNESS METER OPTION (+LM-C, +LM-P) MANUAL SUPPLEMENT
Chapter 1
Introduction
Chapter 1
®
or COMPASS
®
or
®
host card
1-1
Advertisement
Table of Contents
