Advertisement
Replacement
and Care of Filters (continued)
c. Install new tilters in the tilter hous-
ing track with the glue beads of the
wicking
pad to the inside of the filter
housing.
d. Return the top cover of the filter
housing
by installing
the cover over
the fixed tabs on the rear of the
lower tilter housing and pivoting the
cover down over the top of the fil-
ters. Snap the cover over the two
spring tabs.
e. Replace
the tilter housing
in the
cabinet.
Note: There is a left and a
right tilter housing.
There is also a
front and back orientation.
To posi-
tion the filter housings
correctly:
Spring
Tabs
Front of
Humidifier
Fixed
Tabs
Filter
Rear of
• Make sure the two indents
in the
cylinder
section of the top covers
are positioned
towards
the center
of the cabinet.
• Be sure that the spring tabs of fil-
ter housings
are towards
front of
Top
cabinet.
Cover
• Align the lower portion
of the filter
assembly
over the six ribs located
at the bottom
rear of the humidi-
tier cabinet.
Indents
Towards
Center
Cabinet
fo Position fan assembly
onto the cab-
inet. Make sure the fan venturi (low-
est cylinder
section
below the fan)
is placed inside the tilter housing.
g. Replace water bottles.
h. Close the pivoting lid on the fan
assembly.
i. The unit is ready for use or to be
"stored away for next season.
NOTE:
For correct
operation
of the filter
housing
assembly,
tilters
n_ust be fully
contained
inside
the
flange
of the
top
cover.
Flat Portion of Filter Housing
Towards
Back of Cabinet
Indents Toward Center
of Cabinet
Step 4.e.
1o
Advertisement
