Advertisement
15. Separate
the ends of the Conirol
Stand (29) and slide
the Plastic Sleeve
(30) onto one end. Bring the ends
tOgether and _enter the Plastic Sleeve
between
them.
Plug one end of the Control Cord (27) into the Hand
Control (28). Plug the other end of the Cord into the
Wire Adapter
(74) at the front of the system.
Attach the Hand Control (28) to the Control Stand (29)
with the two 1/2" Tap Screws
(31).
Plug the Power Cord (26) into the socket at the back-
of the system.
15
27
OPERATION AND ADJUSTMENT
Plug the transformer
on the power cord into a 120-vott outlet. Keep the power cord away from
walkways
and heated
surfaces.
Turn on the power when using the system,
or the system
could
be
damaged.
When you are finished
using the system, always
unplug the transformer.
DIAGRAM
OF THE HAND CONTROL
1.
Low/High
Range IndicatornShows
when the system is
set at minimum
or maximum
weight.
2.
Weight Display--Displays
the current weight
setting.
3.
Power Button--Turns
the power on and off.
4.
Weight Decrease
Button--Decreases
the weight.
5.
Weight Increase
Button--Increases
the weight.
1
3--
4--
I,
I
I-'1
l iJ._3 t" m l
!'''L
"UII
2
5
TURNING
ON THE POWER
AND RESE'n'ING
THE SYSTEM
Press the power button.
IMPORTANT:
Each time the power
is turned
on, the system
must be reset
before
the weight
can be changed.
The weight
display
will read "E--."
To reset the system,
press
the weight
increase
or decrease
buttons
until
the display
reads
"H250"
(maximum
weight)
or "L30"
(minimum
weight).
CHANGING
THE WEIGHT
SETTING
OF THE SYSTEM
The weight can be changed
from a minimum
of 30 pounds,
up (0 a maximum
of 250 pbunds,
in incre-
ments of 1 pound. To increase
the weight,
press the weight increase
button. To decrease
the weight,
press the weight decrease
button.
The buttons
can be held down to change
the weight quickly.
IMPORTANT:
To prevent
damage
to the system,
do not put any tension
on the system
while
changing
the weight.
Do not push
onthe
butterfly
arms,
ab arm or leg lever, if the lat bar is
attached
to the system,
it may be helpful
to support
the weight
of the lat bar with one hand.
The
system motor will emit a sound to alert you while the weight
Is being changed.
Advertisement
