Advertisement
ASSEMBLY
Place all parts in a cleared
area and remove
the packing
materials.
Do not dispose of the packing
materials
until assembly
is completed.
Read all steps carefully
before beginning.
See the PART I.D.
CHART accompanying
this manual
for a drawing
of each small part used In assembly
and for a
list of the tools needed. The assistance
of a second person
is recommended.
.
.
.
Press the four 2" x 2" Outer Caps (13) onto the
Stabilizer
(2). Turn the Stabilizer
so the indicated
bracket
is on top. Insert the four 3/8" x 2 1/2" Carriage
Bolts (87) up through
the Stabilizer
as shown.
Place the Frame (1) over the two indicated
3/8" x
2 1/2" Carriage
Bolts (87) as shown.
Finger tighten
two 3/8" Nuts (89) with 3/8" Lock Washers
(88) onto
the Carriage
Bolts.
Remove the 3/8" x 3/4" Bolt (35), the Cable Hook "(48),
the extra washer
(A), and the 3/8" Nylock
Nut (6)
which secure the Lower Cable
(76) to the Frame (1)
as shown in the inset. Do not release
the Cable until
completing
this assembly
step. The 3/8" x 3/4" Bolt
(35) and the 3/8" Nylock Nut (6) will be used in
assembly step 3 below. The Cable Hook will be used
later. The extra washer should
be discarded.
Lower Cable (76) under the Pulley. Attach
the Pulley
to the Stabilizer
(2) with a 3/8" x 1 3/4" Bolt (18) and
3/8" Nylock Nut (6) as shown.
Do not overtighten
the
Nut. The Pulley
should
turn
freely.
Attach the Foot Plate (34) to the Frame (1) with the
two 3/8" x 3/4" Bolts (35) and two 3/8" Nylock Nuts (6).
Press the Backrest
Post (63) at the lower end of the
Backrest
(36) into the Frame (1) as shown.
Attach
the
upper end of the Backrest
to the Frame with the 1/4" x
2 1/2" Bolt (37) and a 1/4" Lock Washer
(7).
,
,
'
,,
;.
@-89 13-t_
"
J_"88
13 Bracket_.._!/.
"_,
.............
87
'
I
2
i
/ 7e', %
-
Advertisement
