Cleaning And Applying Detergent - Briggs & Stratton BRUTE Operator's Manual

.
o For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), sebct red 0° spray tip.
o To apply detergent, appibs project specific cbaners
to hdp break down stubborn dirt and grime on a
variety of surfaces, sebct Nack detergent spray tip.
Puff back on collar, insert new spray tip and releasecollar.
Tug on spray tip to makesure it is securelyin place.
Usage Tips
o For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface.
o if you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
o DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Detergent
WARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in death,
serious injury, and/or property damage.
o DO NOTuse caustic liquid with pressure washer
o Use ONLY pressure washer safe detergents/soaps, Follow aii
manufacturers instructions,
Te apply detergent, feiiew these steps:
1. Review use of spray tips.
2. Prepare detergent solution as required by job
3. Hace end of detergent siphoning tube into detergent
container.
NOTICE Make sure the siphoning tube is fufly submerged in
detergent while applying detergent.
NOTICE Contact with the hot muffler could damage
detergent siphoning tube.
, Wheninserting the siphoninto a detergent s olutionbottle,route
thetubeso asto keepit from inadvertently c ontacting the hot
muffler.
4. Make sure black detergent spray tip is installed.
NOTICE Detergent cannot be @priedwith the high pressure
spray tips (White, Yellow or Red).
5. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray
gun and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
, Startingtheenginewithoutall thehosesconnected andwithout
thewaterturnedONcoulddamage the pump.
* Damage to equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
6. Start engine following instructions How to Start Your
Pressure Washer.
7. Apply detergent to a dry surface, starting at lower
portion of areato be washed and work upward, using
long, even, overlapping strokes.
8. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOTallow detergent to dry on
(prevents streaking).
NOTICE You must flush the detergent siphoning system
after each use by placing the siphoning tube into a bucket of
clean water, then run the pressure washer in low pressure
for 1-2 minutes.
15