Sunlighten Signature I Assembly Instructions

Hide thumbs Also See for Signature I:

Table of Contents

Download this manual

S i g n a t u r e I

b y S u n l i g h t e n

T M

A x 1

B x 1

C x 1

D x 1

A S S E M B L Y I N S T R U C T I O N S

E x 1

F x 1

G x 1

H x 1

K x 4

N x 2

W x 4

V e r s i o n 0 4 1 7 2 0 1 8

J x 1

M x 4

N x 1

Table of Contents

Need help?

Do you have a question about the Signature I and is the answer not in the manual?

Page 1 S i g n a t u r e I A S S E M B L Y I N S T R U C T I O N S b y S u n l i g h t e n V e r s i o n 0 4 1 7 2 0 1 8 E x 1 A x 1...
Page 2 STEP 1 DEDICATED 120V | 15A CIRCUIT REQUIRED* see manual A x 1 P x 1 Attach the feet pegs with supplied Allen wrench and W x 4 bolts. K x 4 Cut the zip ties holding the floor grate, the W x 4 fabric will adhere to the Velcro on the underside of the grate.
Page 3 STEP 4 Make connection here. If you have not yet done so, the floor heaters will need to be connected to the right wall wires. The diagram to the right shows where the connection is made. You will need to remove the floor grate and a small hatch covering the harness.
Page 4 STEP 7 B x 1 M x 1 Once all the U-clips have been inserted in the corners, the next step will be to place the roof on top. Make sure the side the main powercord receptacle faces the back. M x 1 STEP 8 The following connections need to be made on the...

Signature iii