Suburban DYNALINE DL3-0712 Owner’s Manual Installation, Operating And Service Instructions page 9

SURFACE OF FINISHED INTERIOR WALL
CABINET FRONT
X" REPRESENTS EITHER THE
DIMENSION REQUIRED TO FLUSH
SLEEVE TO FINISHED TRIM OR
MOLDING, OR THE DISTANCE
SLEEVE PROJECTS INTO ROOM
BEYOND FINISHED INTERIOR
WALL.
NOTE: X" CAN BE 0"
IF SLEEVE IS FLUSH
1"
WITH FINISHED
3 (MIN.)
2
INTERIOR WALL.
DRAIN TUBE ASSEMBLY INSTALLED
ON REAR FLANGE OF WALL SLEEVE
PRIMARY DRAIN HOLES FOR
CONDENSATE DRAINAGE TO
BUILDING EXTERIOR WHEN NOT
USING ACCESSORY DRAIN KITS.
CAULK (MUST BE WATER TIGHT).
(1) INSTALL UNIT IN WALL AS DESCRIBED IN INSTALLATION MANUAL.
(2) POSITION LEVELING LEG--ONE ON EACH SIDE OF WALL SLEEVE
AND LOCATE FOUR (4) MOUNTING HOLES.
(3) DRILL FOUR 1/8" DIA. HOLES AND MOUNT LEGS USING #10 X 1/2" SCREWS PROVIDED.
(4) LEVEL UNIT BY ADJUSTING SCREW IN LEG.
5" MAX./3 1/2" MIN.
FRONT VIEW
LEVELING LEGS INSTALLATION
Y" Y" = 14
X"
SURFACE OF FINISHED
FLOOR OR TOP OF CARPET
WALL INSTALLATION
FRONT GAS HOOKUP
Figure 6
LOCATE DRAIN IN
BOTTOM OF WALL
SLEEVE. MUST BE
TO THE EXTERIOR
SIDE OF BUILDING.
AT DESIRED LOCATION
MARK AND DRILL ONE
9/16" DIA. HOLE AND
TWO 1/8" DIA. HOLES
AS ILLUSTRATED.
Figure 7
SURFACE OF FINISHED FLOOR
OR TOP OF CARPET
Figure 8
9
3 1
- ( X" + )
4 4
SURFACE OF FINISHED EXTERIOR WALL
CAULK AROUND WALL SLEEVE
REAR GRILLE
MOUNTING HOLES AND SCREWS
(BY INSTALLER.)
DO NOT PUT HOLES THROUGH
WALL SLEEVE BOTTOM!
1"
SLOPE DOWN TO THE OUTSIDE
4
1"
MIN. (PROJECTION BEYOND EXTERIOR WALL)
4
DRAIN TUBE ASSEMBLY INSTALLED
UNDERNEATH WALL SLEEVE
NOTE: FOR THIS TYPE INSTALLATION,
WALL SLEEVE MUST EXTEND BEYOND
WALL A MINIMUM OF 1 1/8".
CAULK (MUST BE WATER TIGHT).
CABINET FRONT
WALL SLEEVE
1"
4
LEVELING LEGS
SIDE VIEW
Suburban DynaLine Owner's Manual 10/2017 Rev.1
SLOPE DOWN TO
THE OUTSIDE