Suburban DYNALINE DL3-0712 Owner’s Manual Installation, Operating And Service Instructions page 10

CABINET FRONT
2 (MIN.) SUPPORTS
(BY INSTALLER)
3
CENTER LINE LOCATION FOR REAR GAS
CONNECTION
1 9/16"
TOP VIEW
CENTER LINE LOCATION FOR
2 9/64"
ELECTRICAL CONNECTION ON
7 3/4"
UNIT WHEN INSTALLED INTO
WALL SLEEVE
CENTER LINE LOCATION FOR FRONT GAS CONNECTION
WHEN INSTALLED INTO WALL SLEEVE
Figure 10
THERMOSTAT SWITCH: SLIDE #1 SWITCH
TO "ON", SWITCH #2 REMAINS IN "OFF"
POSITION
REMOTE THERMOSTAT TERMINAL BLOCK
NOTE: THERE IS A 5/8" HOLE IN THE BASE NEAR THE JUNCTION BOX FOR ROUTING THE WIRING
FOR REMOTE THERMOSTAT. THE 5/8" STRAIN RELIEF BUSHING PROVIDED IN THE PACK-OUT BAG
SUPPLIED WITH THE UNIT MUST BE USED TO SECURE THE THERMOSTAT WIRING FOR
REMOTE THERMOSTAT.
Figure 12
Suburban DynaLine Owner's Manual 10/2017 Rev.1
1"
2
WALL SLEEVE
1"
(MIN.)
2
SURFACE OF FINISHED
FLOOR OR TOP OF CARPET
WINDOW, CURTAIN WALL, OR WALL PANEL INSTALLATION
WALL SLEEVE (OUTLINE)
UNIT (OUTLINE)
FRONT SURFACE
OF WALL SLEEVE
MODULE BOARD (LOCATED
ON CONTROL PANEL)
(MAX.) LONG SCREWS FOR SECURING
ANGLES TO TOP & SIDES OF SLEEVE.
WINDOW OR WALL
CAULK AROUND WALL SLEEVE
REAR GRILLE
WALL SLEEVE ANGLES & SCREWS
(BY INSTALLER.)
DO NOT PUT HOLES THROUGH OR DRIVE
SCREWS INTO WALL SLEEVE BOTTOM!
1"
SLOPE DOWN TO THE OUTSIDE
4
1"
MIN. (PROJECTION BEYOND WALL)
4
Figure 9
SYSTEM
FAN
10
STANDBY
HEAT
COOL
FAN ONLY
WARMER COOLER
SET
HIGH
LOW
Figure 11
DISPLAY PANEL
CONTROL ROD
(FRESH AIR VENT)
Figure 13