Suburban DYNALINE DL3-0712 Owner’s Manual Installation, Operating And Service Instructions page 15

This optional package allows for distribution of air into an adjacent zone requiring a controlled temperature. This assembly will discharge the
conditioned air to either the right or left depending upon which end the cap is placed. (See Figure 23.)
This package, when installed on a DL3-0712 and DL3-0912 series cannot be lengthened. Maximum length, not including adaptor, is 43 1/4". On
model DL3-1220 and DL3-1622, additional lengths may be added.
If additional length is required, connector assembly (No. 1624) may be used. No more than two (2) connectors may be used. Maximum length not
including the adaptor is 130" (10.8 Feet). NOTE: Installer must provide wall support brackets for the connector and extension. Not recommended
for use on models with built-in thermostats.
BOTTOM OF SLEEVE TO TOP OF
AIR DISCHARGE ADAPTOR
Figure 20
4 PIN FEMALE HOUSING
RESET
BUTTON
TEST/HUSH
DL3 AIR DISCHARGE PACKAGE
STOCK NO. 1651 - ADAPTOR
STOCK NO. 1623 - EXTENSION
STOCK NO. 1624 - CONNECTOR
INTRODUCTION
4 PIN MALE HOUSING
(ONLY FOR UNITS WITH
OPTIONAL CARBON
MONOXIDE DETECTOR)
BUTTON
OPTIONAL CARBON MONOXIDE DETECTOR
GRILLE
SCORE LINE
BAFFLE
ADAPTOR (1651)
TINNERMAN
CAP
Figure 22
15
EXTENSION (1623)
CONNECTOR (1624)
ADAPTOR
COLLAR
(SEE DETAIL VIEW)
BRACKET
CHANNEL
DL3 DYNALINE INSTALLED IN WALL.
(SHOWN ONLY FOR THE PURPOSE OF
ILLUSTRATING AIR PACKAGE INSTALLATION).
Figure 21
Suburban DynaLine Owner's Manual 10/2017 Rev.1
DETAIL VIEW
COLLAR