Makita AG125 Instruction Manual page 8

1
1. Hole
2. Metal plate
1. Exhaust cover
8
NOTE:
• The nailer will not operate unless you apply sufficient pressure to the
contact arm. If this occurs, apply forward pressure to the nailer again
while pulling the trigger to start operation.
Nailing with one or two impacts
005376
When you need to position a nail or drive a shallow nail
1. Set the tip of the nail firmly against the driving surface.
2. Pull the trigger.
3. Withdaw the nailer from the driving surface immediately after one or two
impacts.
NOTE:
• The impacts will continue as long as you keep the nailer pressed up
against the driving surface, even if you release the trigger.
Nailing in metal plate holes
005377
CAUTION:
2
• Always make sure that the tip of the nail is inserted in the hole in the
metal plate before you start nailing.
Air exhaust
005378
1
Air exhaust direction can be changed easily by rotating the exhaust cover.
Change it when necessary.