Cabinet Venting Preparation - IKEA EVENTUELL Installation Instructions And Use & Care Manual

2. Locate side mounting bracket flush to the bottom of the cabinet
side and against the inside of the front cabinet face. Orient the
bracket as shown in the following illustration. Drill ¹⁄₈" (3 mm)
pilot holes in 8 places, attach a bracket using four 4.5 x 13 mm
#2 Phillips screws to each side of the cabinet, and tighten.
Additional plastic washers in hardware package are supplied as
spacers for cabinet walls thinner than ½" (13 mm).
Bracket Orientation for 30" (76.2 cm) Cabinet
B
A
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm #2 Phillips (8)
C. Metal washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)

Cabinet Venting Preparation

1. Complete cabinet preparation following the instructions for
your type of venting. Determine venting cutout locations and
cut out vent openings in the cabinets, walls and/or soffit.
Venting Outside Through the Roof
Measure and mark the lines as shown. Use a saber saw or
keyhole saw to cut an opening through the top of the cabinet
and the roof for the vent.
Go to Step 2.
A
A. Cutout
B. 6¼" (15.9 cm)*
³⁄₄
C. 7 " (19.7 cm) centerline to cabinet front
D. Centerline
*NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide
(15.9 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
10
C
D
C
B*
D
Venting Outside Through the Wall
Install the 6" (15.2 cm) vent transition to the top of the range
hood liner using two 3.5 x 9.5 mm T10 screws. Assemble the
vent duct that you will use over the 6" (15.2 cm) vent
transition. Measure from the bottom of the range hood liner to
the horizontal centerline of the vent opening (A).
B
A
A. Measurement A
B. Horizontal centerline of vent opening
C. 3.5 x 9.5 mm T10 screws
D. Range hood liner
Remove the vent duct from the range hood liner.
Transfer measurement A to the cabinet back wall. Measure
from the underside of the cabinet. Mark the cutout as shown.
Use a saber saw or keyhole saw to cut a round opening
through the back of the cabinet and the exterior wall for the
vent.
Go to Step 2.
A
B
A. Measurement A
B. Centerline
C. 6¼" (15.9 cm) round cutout
C
D
C